What Am I

5-MeO-DMT vape cart without carrier liquid (PG)

2 posts in this topic

I've noticed a few posts on the DMT subreddit where people are loading carts with straight DMT freebase in crystal form and then heating the cart with something like a hairdryer to melt the DMT into liquid form. At this point, they claim to be able to vape it with the same ease as a PG/DMT mix, with the obvious difference that it's now much stronger and you can avoid ingesting the unwanted chemical of PG.

Anyone ever try something similar with 5-MeO-DMT? The main difference I see is in the two molecules' melting points. DMT freebase melts at ~104F and 5-MeO-DMT freebase melts at ~151F. It's hard to say without doing some testing, but the higher melting point may be an issue in performing this method. At least for DMT freebase, it stays melted for 30-60 minutes after heating and then recrystalizes in the cart.

https://www.reddit.com/r/DMT/comments/1bgkcn9/dmt_vape_no_pgvg/

https://www.reddit.com/r/DMT/comments/n1mwf3/no_pg_required_just_heat_the_cart_until_its_all/

Edited by What Am I

Share this post


Link to post
Share on other sites

As an update, the act of melting 5-MeO-DMT freebase when it's loaded into a cart is not difficult. While carefully holding the cart in front of a miniature 500w personal space heater, it only took a couple minutes to thoroughly melt the substance. I didn't try actually using it yet, but it appeared to remain in a vape-able state for at least 30 minutes.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now